What you need to know about power washing tips, Online property advice, House guide

What do you need to know about power washing?

13 September 2021

Power washing is a great way to clean your home’s exterior, and you can also use it for other tasks. It uses low-pressure water that you can adjust depending on the surface you’re cleaning.

What you need to know about power washing guide

Here are some more helpful power washing tips:

* Avoid using high pressure when power washing new wood siding or cedar shakes because it will strip the finish off the new wood before it has a chance to cure (dry). You’ll want to wait several months until the siding is cured before power washing it. The same goes for bare plywood or soft lumber around newly built homes or sheds, which may not have dried completely yet.

* Make sure your landscaping won’t get washed away by an unexpected downpour of water from your power washer. Also, make sure your plants are protected; the pressure of the water could damage them. Consult Baltimore Power Wash for the bests services

* When applying soap or detergent with your power washer, always spray down your deck first to avoid streaking before rinsing it off.

* Make sure you’re using a starter nozzle when you begin because this will allow for proper adjustment later on if necessary. You should also get yourself an extension cord if you haven’t already so that you don’t have to maneuver around the electric outlet while cleaning unruly areas like patios and decks. And lastly, remember not to use flammable liquids near electrical outlets!

It’s that time of year again when many homeowners are gearing up to do some power washing on their homes. Before you start blasting away with the nozzle, though, there are a few things you should know about using this technique.

Possible damage from high-pressure washing

Although power washers can make quick work of removing mold or mildew from your siding or brick house exterior, these units can also cause irreversible damage if not used properly. One problem is “water-spilling” – caused by high-pressure water blasting at too great an angle to wash the surface. This creates small craters in concrete driveways and walkways. For building exteriors, always be sure to use low pressure (1,000 to 2,000 PSI) for brick or masonry, or use a chemical compound that etches the surface (this is especially important to reduce the risk of water-spilling).

For smooth surfaces like siding and windows, use medium pressure (1,500 to 3,000 PSI) and try not to spray at too steep an angle. And if your project involves cleaning vinyl siding, be sure to get it done before winter sets in; since this exterior material cannot “breathe,” water can get trapped between the house wrap and cladding during cold weather and expand when things warm back up next spring. This could cause serious damage.

Pressure washers are an extremely efficient way of cleaning just about anything, but they’re not as easy as you might think. Pressure washing can be dangerous if you don’t follow simple safety precautions and tips for using your pressure washer.

Always read the owner’s manual thoroughly before operating your power washer. Don’t try to operate it until you understand how it works completely and until you’ve mentally prepared yourself for dealing with high-pressured water. Be aware of what can happen if something goes wrong because it will happen sooner or later no matter who uses the pressure washer or how many they’ve used one previously.

Comments on this guide to what you need to know about power washing article are welcome.

Building Articles

House designs

Restoration building designs

Interior designs + architects

Pressure washing technique
Pressure washing technique guide

New Homes

Telluride Glass House, Telluride
Design: Efficiency Lab for Architecture
Telluride Glass House Colorado
photograph : Josh Johnson
Telluride Glass House

Apartment Designs

Comments / photos for the What you need to know about power washing tips page welcome